D-Link DFL-1600 User Manual page 253

22.2. PPTP/ L2TP
Example:
This example describes how to set up a PPTP client. The PPTP server is
located at 10.0.0.1 and all traffic should be routed over the PPTP tunnel.
WebUI
:
1. PPTP Client
First step is to configure the PPTP client.
Interfaces
Client:
Enter the following:
Name: PPTPClient
Tunnel Protocol: PPTP
Remote Endpoint: 10.0.0.1 (The IP of the PPTP server)
Remote Network: 0.0.0.0/0 (all-nets, as we will route all traffic into the
tunnel)
Username: The username provided to you by your service provider.
Password: The password provided to you by your service provider.
Confirm Password: Retype the password.
We keep the default settings for authentication and encryption.
dial-on-demand is enabled, the tunnel will only be up when there is traffic
on the PPTP client interface. It is possible to configure how the firewall
should sense activity on the interface, and how long time to wait with no
activity before the tunnel is disconnected. Then click OK
Configuring PPTP Client
L2TP/PPTP Clients
D-Link Firewalls User's Guide
Add L2TP/PPTP
233
If