Dynamic (Cable) - D-Link DIR-605 User Manual

Section 3 - Configuration
To manually set up the Internet connection, click the Manual Internet Connection Setup button on the Router's
opening window.
Access Checking this box disables NAT and turns the Router into
Point
an Access Point only.
Mode:
Dynamic IP Choose Dynamic IP Address to obtain IP Address
Address: information automatically from your ISP. Select this option
if your ISP does not give you any IP numbers to use. This
option is commonly used for Cable modem services.
Host
The Host Name is optional but may be required by some
Name:
ISPs. The default host name is the device name of the
Router and may be changed.
MAC Address: The default MAC Address is set to the WAN's physical
interface MAC address on the Broadband Router. It is not
recommended that you change the default MAC address
unless required by your ISP.
Clone MAC
The default MAC address is set to the WAN's physical
Address:
interface MAC address on the Broadband Router. You
can use the "Clone MAC Address" button to copy the MAC
address of the Ethernet Card installed by your ISP and
replace the WAN MAC address with the MAC address
of the router. It is not recommended that you change the
default MAC address unless required by your ISP.
Enter the DNS (Domain Name Server) server IP address assigned by your ISP.
DNS
Addresses:
MTU: Maximum Transmission Unit - You may need to change the MTU for optimal performance with your specific ISP.
D-Link DIR-605 User Manual
Internet Setup
Dynamic
19