Canon imagePROGRAF W8400 User Manual page 91

Printing with Rolls Media
4
Place the roll media end at the bottom, and
insert the shaft of the roll holder firmly into
the roll from the right side until the holder
meets the roll.
Caution
Place the roll holder horizontally on a table, and then
load the roll holder. The roll media is heavy, so
dropping it may cause an injury.
Important
If the edge of the roll paper is not straight, take up the
roll paper until the edge is straight before loading it.
Misalignment of the edges may cause poor paper
feed.
Firmly insert the roll holder into the shaft. Any gaps
may cause poor paper feed.
2- 30
5
Attach the holder stopper to the left side of
the roll holder and insert it until it contacts the
roll media shaft, then push the holder
stopper lever (a) over toward the shaft to lock
it.
The roll media is locked in place by the roll holder.
Important
If the edge of the roll paper is not straight, or there is
blot or imprint of a tape. This could cause poor paper
feed and reduce printing quality. In these cases, cut
the edge of the roll media before loading the roll holder
to the printer.
a
TOP
Chapter 1
Basic Use
Chapter 2
Using Various Media
Chapter 3
Printing by Objective
Chapter 4
Maintenance
Chapter 5
Using the Printer
in a Network
Environment
Chapter 6
Troubleshooting
Chapter 7
Operating the
Function Menu
Contents
Index