Loading Roll Media; Printing With Rolls Media - Canon imagePROGRAF W8400 User Manual

Printing with Rolls Media

Printing with Rolls Media

Loading Roll Media

This is the general procedure for loading roll media.
After printing remove the completed printout and any
media loaded on the platen. (→ P.2-35, P.2-42)
On the operation panel, select the roll media source.
(→ P.2-28)
Load the roll media in the roll holder slot. (→ P.2-29)
Load the roll media on the platen. (→ P.2-32)
On the printer operation panel, select the media type.
(→ P.2-32)
Adjust the amount of media feed. (→ P.4-43)
Start the print job from the computer. (→ P.1-38)
Important
Make sure to turn off the power supply to the printer
before loading the roll media. Further, if the loaded
media differs from the media type setting, the print
quality may be reduced.
The roll media remaining detection function cannot be
used for Tracing Paper or Translucent Matte Film.
When using a Tracing Paper roll or Translucent Matte
Film roll, switch off the roll media remaining detection
function before loading the roll.
2- 28
Selecting the Paper Source
When printing on roll media, select roll media as the
paper source using the operation panel.
1
Press and hold the Paper Source button for
1 second or more to light the Roll Media
lamp.
Information Power
Data
Offline
Feed Paper
Message
Cleaning
(3 sec.)
Stop/Eject
(1 sec.) Online
When cut paper is loaded, the printer will display
Remove CutSheet?.
If you have loaded another roll, press and hold the
Stop/Eject button for 1 second or more to display
Remove RllMedia?.
2
If the cut sheet or roll media is set to the
printer, press the OK button.
Remove CutSheet?
Press OK/Stop
Remove the cut sheets or roll media.
(→ P.2-35, P.2-42)
Offline
Menu
TOP
Chapter 1
Basic Use
Chapter 2
Using Various Media
Chapter 3
Printing by Objective
Chapter 4
Maintenance
Chapter 5
Using the Printer
in a Network
Environment
Chapter 6
Troubleshooting
Chapter 7
Operating the
Function Menu
Contents
Index