Canon imagePROGRAF W8400 User Manual page 100

Printing with Cut Sheets
When you set the cut sheet with roll paper loaded in
the printer, the media may be damaged.
Loading Cut Sheets
Load the cut sheets into the platen using the following
procedure. If there are cut sheets or printed sheets still
on the platen, remove them first.
Note
The platen may be fouled with ink so clean inside the
top cover before you switch to printing on a large size.
(→ P.4-11)
For more details about media that can be set, refer to
"Media You Can Use". (→ P.2-2)
If the paper is creased, the paper and printhead may
be misaligned, so smooth out any paper creases.
2- 39
1
Open the top cover, and lift the release lever.
Important
Do not touch any areas other than those indicated. Your
hands could get dirty or this could damage the printer.
2
With the print side of the cut sheet facing up,
hold the sheet square between the
paperweight, making sure that the stack is
aligned with the paper alignment line (a) on
the right and aligned with the paper
alignment line (b) at the back.
When the cut sheet is inserted, it is held against the
platen by vacuum force.
Chapter 1
Basic Use
Chapter 2
Using Various Media
Chapter 3
Printing by Objective
Chapter 4
Maintenance
Chapter 5
Using the Printer
in a Network
Environment
Chapter 6
Troubleshooting
b
a Chapter 7
Operating the
Function Menu
TOP
Contents
Index