Show Service Ingress-Label - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

show service ingress-label

Displays the services that are using a specific ingress label or a range of ingress labels.
show service ingress-label start-label [end-label]
Syntax Definitions
start-label
end-label
Defaults
By default, all services associated with the starting label number are displayed.
Platforms Supported
OmniSwitch 9000E
Usage Guidelines
•
Use the optional end-label parameter along with the start-label parameter to specify a range of ingress
labels.
•
If an ending label number is not specified, then all services using the starting label number are
displayed. No range is specified.
Examples
-> show service ingress-label 2048 131071
Martini Service Labels
Svc Id Sdp Binding
----------+------------------+-----+---------------------+---------------------
100 10:100
200 30:200
Number of Bindings Found : 2
output definitions
Svc Id
SDP Binding
Type
I.Lbl
E.Lbl
page 50-106
An ingress label number. The valid range is 0 or 2048–131071.
The last ingress label number in a range of labels. The valid range is
2049–131071.
Type I.Lbl
Mesh 131069
Mesh 0
The unique service identification number used to identify the service.
The SDP ID number associated with the service.
Indicates the SDP binding type (mesh or spoke) for the service. The
spoke SDP binding type is not supported.
The VC label used by the far-end device to send packets to the local
device for this SDP binding.
The VC label used by the local device to send packets to the far-end
device for this SDP binding.
Virtual Private LAN Service (VPLS) Commands
E.Lbl
131070
0
OmniSwitch CLI Reference Guide June 2012