Show Running-Directory - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

show running-directory

Shows the directory from where the switch was booted.
show running-directory
Syntax Definitions
N/A
Defaults
N/A
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
Once a switch has booted and is running, it will run either from the working or certified directory. If
running from the certified, changes made to the running configuration using CLI commands cannot be
saved. A switch must be running from the working directory in order to save the current running
configuration.
•
This command can also be used on the secondary CMM.
Examples
The following is an example of the display on OmniSwitch 6850 Series switches:
-> show running-directory
CONFIGURATION STATUS
Running CMM
CMM Mode
Current CMM Slot
Running configuration
Certify/Restore Status
SYNCHRONIZATION STATUS
Flash Between CMMs
Running Configuration
Stacks Reload on Takeover: ALL STACKs (SW Activation)
output definitions
Running CMM
CMM Mode
Current CMM Slot
page 53-18
: PRIMARY,
: DUAL CMMs,
: 1,
: WORKING,
: CERTIFY NEEDED
: SYNCHRONIZED,
: NOT AVAILABLE,
The CMM currently controlling the switch, either PRIMARY or
SECONDARY.
Displays whether the primary and secondary CMMs are synchronized.
In the case that there is no secondary CMM, MONO-CMM-CHASSIS
is shown.
The slot number of the primary CMM.
OmniSwitch CLI Reference Guide
CMM Commands
June 2012