Omron SYSDRIVE 3G3JV Setup Manual page 52

List of Parameters
Param- Name
eter
No.
(Regis-
ter No.
(Hex))
n40 Multi-func-
tion output p
(0128) (0128)
(MA/MB
and MC
output ter-
minals) minals)
3-12
Description
Used to select the functions of multi-function
output terminals.
Set Function
val-
ue
0 Fault output ON: Fault output (with
protective function work-
ing)
1 Operation ON: Operation in prog-
in progress ress
2 Frequency ON: Frequency detection
detection (with frequency reference
coinciding with output fre-
quency)
3 Idling ON: Idling (at less than
min. output frequency)
ON: Output frequency y
4 Frequency
detection 1 frequency detection level
(n58)
ON: Output frequency x
5 Frequency
detection 2
frequency detection level
(n58)
6 Overtorque Output if any of the fol-
being moni- lowing parameter condi-
tions is satisfied.
tored (NO-
contact out-
n59: Overtorque detec-
put)
tion function selection
n60: Overtorque detec-
tion level
n61: Overtorque detec- 61 O
7 Overture
tion time
being moni-
tored (NC-
NO contact: ON with
contact out-
overtorque being
put)
detected
NC contact: OFF with
overtorque being
detected
8 Not used ---
9
10 Alarm out- ON: Alarm being de-
put tected (Nonfatal error be-
ing detected)
11 Base block Base block in progress
in progress (in operation with output
shutoff)
12 RUN mode ON: Local mode (with the
Digital Operator)
Set-
ting
range
0 to 7,
10 to 0
18
Description
d
Chapter 3
Default Changes Memo
setting during
opera-
tion
1 No