Setting On/Off Angles In Manual Mode; Setting On/Off Angles In Teaching Mode - Omron H8PS Manual

Setting ON/OFF Angles in Manual Mode

ON/OFF angles can be set manually using the ANGLE Keys
on the front of the Cam Positioner.
Example: Setting Step 1 of Cam No. 2 to Turn ON at 28 and
Turn OFF at 51
Change the mode.
Set the mode switch to PRGM.
Set the programming
Set the programming mode switch to MAN.
mode switch.
Mode
PRGM
TEST
RUN
Banks can be specified only for
Set the bank No.
16-/32-output models.
Press the Key to specify the bank number
BANK
and then press the
WRITE
Set the cam and step No.
Press the CAM Keys
Press the STEP Keys
CAM STEP
Set the ON angle.
Press the Key to flash the
ON OFF
Press the ANGLE Keys
and then press the
WRITE
STEP
CAM
Set the OFF angle.
Press the Key to flash the
ON OFF
Press the ANGLE Keys
and then press the
WRITE
CAM STEP
End
Note: Pressing the or Key continually will automatically increment or
decrement the value. Pressing the other key during automatic increment
or decrement will increase the speed.
22
Cam Positioner
Programming mode
TCH
MAN
Key.
to specify cam No. 2.
to specify step No. 1.
PRG
" "
.
ON
to set an angle of 28
Key.
PRG
" "
.
OFF
to set an angle of 51
Key.
PRG
H8PS
Setting ON/OFF Angles in Teaching
Mode
ON/OFF angles can be set based on actual machine (Encoder)
operation.
Example: Setting the ON/OFF Angles by Teaching Step 2 of
Cam No. 3
Change the mode.
Set the mode switch to PRGM.
Set the programming
Set the programming mode switch to TCH.
mode switch.
Mode
PRGM
TEST
RUN
Banks can be specified only for
Set the bank No.
16-/32-output models.
Press the Key to specify the bank number and
BANK
then press the Key.
WRITE
Set the cam and step No.
Press the CAM Keys
Press the STEP Keys
CAM STEP
Set the ON angle.
Press the Key to flash the
ON OFF
Turn the machine (Encoder) to the desired ON angle.
(195 in this example)
Press the Key.
WRITE
CAM STEP
Set the OFF angle.
Press the Key to flash the
ON OFF
Turn the machine (Encoder) to the desired OFF angle.
(278 in this example)
Press the Key.
WRITE
STEP
CAM
End
Programming mode
TCH
MAN
to specify cam No. 3.
to specify step No. 2.
TST
" "
ON .
TST
" "
OFF .
TST