Instruction For The Installer - Smeg T95PGGSFS Manual

Instruction for the installer

CONNECTION USING RUBBER HOSES COMPLYING WITH THE CURRENT REGULATIONS IS
ONLY PERMITTED IF THE HOSE CAN BE INSPECTED ALONG ITS ENTIRE LENGTH.
2.4.3 Connection to liquid gas
Both the pressure regulator and the connection to the cylinder must be standards-compliant.
Make the connection to the gas mains using a rubber hose whose specifications comply with the
current regulations (verify that the reference standard is stamped on the hose).
After having installed the connector as
indicated in "2.4.1 Connector installation",
fit the small hose connector E to the large
hose connector D.
Place the seal F between the lock just
obtained and the previously installed
connector.
Then, push the rubber hose onto the hose
connector E and secure it with a clamp
that is compliant with the current standard.
2.4.4 Connection to natural gas
After having installed the connector as
indicated in "2.4.1 Connector installation",
Fit the large hose connector D by placing
the seal F between the previously installed
connector.
Push the rubber hose D onto the hose
connector A and secure it with the clamp
E that is compliant with the current
standard.
2.4.5 Connection with a flexible steel hose (for all types of gas)
This type of connection can be made on both built-in and free-standing appliances. Only use
standards-compliant steel hoses whose length is not greater than 2 metres.
After having installed the connector as indicated in "2.4.1 Connector installation", screw the end of the
flexible hose to the threaded ½ external gas connector (ISO 228-1), placing the seal in between.
9