Installing The Usb Module; Vga Module; Removing The Vga Module - Dell EMC E39S Series Installation And Service Manual

Installing the USB module

Prerequisites
Follow the safety guidelines listed in
NOTE: The procedure to install the USB 3.0 and USB 2.0 modules is similar.
Steps
1. Route the USB cable on the USB module, through the USB slot on the front panel.
2. Insert the USB module into the slot on the front panel.
3. Align the screw on the module with the screw hole on the system.
4. Using the Phillips #1 screwdriver, replace the screw to secure the module to the system.
5. Route the USB cable and connect it to the USB connector on the system board. For more information, see the System board jumpers
and connecters section.
Figure 101. Installing the USB module
Next steps
1. Install the air shroud.
2. Install the backplane cover.
3. Follow the procedure listed in

VGA module

Removing the VGA module

Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3. Remove the front bezel
148 Installing and removing system components
Safety instructions on page 71.
After working inside your system
Safety instructions on page 71.
Before working inside your system
on page 72.
on page 72.