How To Set Up The Radar - Furuno TZtouchXL TZT22X Installation Manual

Multi function display
Hide thumbs Also See for TZtouchXL TZT22X:
Table of Contents

Advertisement

3.4

How to Set Up the Radar

1. Tap the [FURUNO] icon to show the home screen and display mode settings.
2. Tap [Radar] from the [Settings] menu.
3. Tap [User Settings], [Radar Source] then tap appropriate radar source.
Note: If a DRS sensor is connected but does not appear in the [Radar Source] list,
close the list and open it again. The name of the DRS sensor should appear with
a check mark, as in the example below.
4. Tap [<] to go back one layer in the menu, then tap [Radar Initial Setup].
5. Referring to the tables on the next several pages to set up the radar.
Menu item
[Own Ship Icon]
[Bearing Scale Mode]
[EBL Reference]
[Antenna Rotation]
[Antenna Heading Align]
[Main Bang Suppression]
[Enable Sector Blanking]
[Enable Sector 2 Blanking]
[Position from Bow]
[Position from Port]
[Height from Surface]
[Antenna Length]
[Auto Tuning]
User
User
[Radar Initial Setup] section
Description
Select to show or hide the own ship icon on
the radar display.
Select the range rings mode.
Select the EBL reference.
Select the speed of antenna rotation. Not
available (grayed out) with DRS4DL+.
See "How to align the antenna
heading" on page 3-13.
If main bang appears at the screen center,
slide the circle icon so that the main bang
disappears, while watching the radar echo
at the left-hand side of the display.
Up to two sectors may be selected for
blanking (no transmission). Select [ON] to
enable this feature. Set the start and end
angles (0° to Se359°).
Referring to the figure on the right,
enter the radar antenna positioning
bow-stern (Longitudinal) and port-
starboard (Lateral) position from
the origin.
Select the height of the antenna above the
waterline.
Not available (grayed out) with DRS4DL+.
Select the length of the antenna.
Enable/disable auto tuning for the connect-
ed radar.
Not available (grayed out) with DRS2D-
NXT/DRS4D-NXT/DRS6A-NXT/DRS12A-
NXT/DRS25A-NXT.
3. HOW TO SET UP THE EQUIPMENT
RD253065-DRS_RADOME
Options (setting range)
[ON], [OFF]
[True], [Relative]
[True], [Relative]
[Auto], [24 RPM]
[-179.9°] to [+180.0°]
[0] to [100]
[ON], [OFF]
[0] m to [999] m
[-99] m to [+99] m
Port-side is negative,
Origin
Origin
Starboard-side is posi-
tive.
[Under 3m], [3m-10m],
[Over 10m]
[1.0m], [1.2m],
[1.8m]
[ON], [OFF]
3-11

Advertisement

Table of Contents
loading

This manual is also suitable for:

Tztouchxl tzt24x

Table of Contents