Furuno TZtouchXL TZT22X Installation Manual page 34

3. HOW TO SET UP THE EQUIPMENT
[Transducer Setup] section
For motion sensor related settings, see "Motion sensor menu" on page 3-18.
Menu item
[Transducer Setup
Type]
[Model Number]
[High Frequency Min]
[High Frequency Max] Display the high frequency maximum.*
[Low Frequency Min]
[Low Frequency Max]
[Reset Default Page
Settings]
*: Shown with connection of DFF3.
Note 1: Make sure that the unit is set to stand-by when setting up the transducer.
Note 2: When using with the DI-FFAMP, DO NOT set the [Model Number] menu if the
[Transducer Setup Type] menu is set to [Model]. This can cause damage to the trans-
ducer.Select [Transducer Setup Type] menu and select the model of connected trans-
ducer at [High Frequency] and [Low Frequency] menus.
Note 3: When the DI-FFAMP is connected and [Transducer Setup Type] menu is set
to [Manual], the message "Power amplifier unit detected: In order to manually adjust
your transducer setup, please contact your Furuno dealer." appears. Contact your
FURUNO dealer for setup.
When [Transducer Setup Type] is set to [Model] and connected to DFF3
Menu item
[High Frequency]
[Frequency Adjust HF]
[Low Frequency]
[Frequency Adjust LF]
3-16
Description
Select the type of transducer connected.
When the connected sounder is a DFF1-UHD and the
transducer has a compatible TDID, [TDID] is automati-
cally selected.
Note: When the transducer model is changed or TDID is
detected, the frequency and bandwidth set on [Manual] is
to be reset.
• [Manual]: Manually set up the transducer.
• [Model]: Select the appropriate transducer model
(for FURUNO or AIRMAR transducers).
Select the appropriate model number from the list.
Note: Only available when [Transducer Setup Type] is set to [Model].
Display the high frequency minimum.*
Display the low frequency minimum.*
Display the low frequency maximum.*
Reset the Transducer Setup menu settings to default.
Set the frequency (kHz) of the connected high frequency transducer.
Fine-tune the high-frequency TX frequency to eliminate interference (set-
ting range: -50 to +50). Set to [0] where there is no interference.
Set the frequency (kHz) of the connected low frequency transducer.
Fine-tune the low frequency TX frequency to eliminate interference (set-
ting range: -50 to +50). Set to [0] where there is no interference.
DO NOT use this menu for selecting DO NOT use this menu for selecting
the connected transducer. the connected transducer.
Description
Options
(setting range)
[Manual],
[Model]
[OK], [Cancel]