Radar; How To Transmit, Set The Radar In Stand-By, Tune - Furuno TZT9 Operator's Manual

6.

RADAR

This chapter provides the information necessary for radar operation.
6.1 How to Transmit, Set the Radar in Stand-by,
Tune
Transmission, stand-by
Press the Home key (or tap the Home icon) to show the display selection window then
select the radar display. Push the RotoKey
menu then select [Tx Radar] to transmit.
If you do not require the radar for some time, set the radar in stand-by to save the mag-
netron from unnecessary use. Push the RotoKey
RotoKey menu then deselect [Tx Radar] to set the radar in stand-by.
You can switch the radar between transmit and stand-by by tapping the radar scale
box at the bottom left-hand corner of the screen.
Range
For TZTBB, tap the area circumscribed above to
Note: You can set the range from the radar scale box by tapping the range indication
(see section 6.5).
Tuning
In default, the radar receiver is tuned automatically after turning the radar to TX. If you
require fine tuning, do the following to tune manually:
1. Select [Menu] on the menu icon bar to open the main menu.
2. Select [Radar].
3. In default, the automatic tuning turns on. First turn off the automatic tuning. Select
the [OFF] icon in [Auto Tuning].
4. Drag the circle icon in [Manual Tuning] to set the value.
5. Select [Close] to exit the menu.
TX mode
Radar scale box
TM
(or tap the screen) to show the RotoKey
TM
(or tap the screen) to show the
Range Stand-by mode
Radar scale box
switch between TX and Stand-by.
6-1