Table of Contents
Advertisement
3. HOW TO SET UP THE EQUIPMENT
11. Use the software keyboard to enter the network key, then tap the [OK] button. To
see what you have input, check [Show characters].
Note: If the network key is incorrect, an error message appears. Enter the correct
key and tap [OK] again.
12. Tap [X] on the title bar to close the menu.
3.6.2
How to create a wireless LAN network
Smart devices connected to this wireless network may also connect directly to the unit,
allowing use of the TZT22X/24X applications.
1. Tap the [FURUNO] icon (
display mode settings.
2. Tap [Settings], [General], [Connectivity].
3. Tap [Wireless LAN Settings].
4. Tap [Wireless Mode] in the [WIRELESS MODE] menu.
5. Tap [Create Local Network], then tap the [<] icon at the top left of the display.
6. Tap [Name] in the [LOCAL NETWORK SETTINGS] menu.
7. Using the software keyboard, name the unit, then tap
8. Tap [Password] in the [LOCAL NETWORK SETTINGS] menu.
9. Using the software keyboard, set the password, then tap
10. Tap [Local Network] in the [ENABLE LOCAL NETWORK] menu to activate the
wireless network.
11. Your smart device may now be connected to the unit, through the network.
1) From the smart device, select the network set at step 7.
2) Input the password set at step 9.
12. Tap [X] on the title bar to close the menu.
3.7
Ferry Mode
Note: Only the SC-30, SC-33, and SCX-20 support the Ferry Mode.
The Ferry mode allows the user to rotate the screen orientation by 180°. Note that all
the above heading sensors must support heading offset command from the TZT22X/
24X. Both the heading sensor and radar sensor must be powered when the TZT22X/
24X sends the heading offset command to them. If TZT22X/24X sends the command
and one of the sensors does not receive it, the heading data may be reversed. See
"[Event Input Configuration]" of "Other menu items" on page 3-8.
3.8
How to Manage Your Charts
The NavNet TZtouch series uses the Mapmedia charts. There are two types of charts,
free and paid. Paid charts require an unlock code. To share the system ID and unlock
code among the NavNet TZtouch units connected on the network, open the Home
page on a NavNet TZtouch unit, then tap [Settings]→[Initial Setup]→[Chart Master
Device]→[ON].
3-20
) to show to show the home screen and
.
.
Advertisement
Table of Contents
