How To Set Up The Radar - Furuno TZTBB Installation Manual

3. SETTING UP THE EQUIPMENT
Menu item
[COG & SOG]
[Heading]
[Speed Through Water]
[Wind Speed & Angle]
[Rate of Turn]
Menu item
[FAX30 Browser]
[FA30 Browser]
[FA50 Browser]
3.3

How to Set up the Radar

If you have a radar sensor, set the sensor's characteristics on the [Radar] menu. Open
the [Menu Radar] sub menus. Drag the main menu to select [Radar].
1. Select [Radar Source] on the [Menu Radar] sub menus, then select the radar type
connected.
Note: If a DRS sensor is connected but does not appear in the [Radar Source] list,
close the list and open it again. The name of the DRS sensor should appear with
a check mark, as in the example below.
3-8
Menu Initial Setup (Data Damping)
Description
Set data damping time. The lower the set-
ting the faster the response to change.
Menu Initial Setup (Browser Installation)
Description
Show the Facsimile Receiver FAX-30 display.
Show the AIS Receiver FA-30 display.
Show the AIS Receiver FA-50 display.
Options (setting range)
0 to 59 seconds
Option (setting range)