Table of Contents
Advertisement
3. HOW TO SET UP THE EQUIPMENT
When [Transducer Setup Type] is set to [Manual] and connected to DFF3-UHD
Menu item
[TX Volt HF]
Not available (grayed out).
[TX Volt LF]
Not available (grayed out).
[High Frequency]
Set the frequency (kHz) of the transducer connected to the high frequency side.
[Low Frequency]
Set the frequency (kHz) of the transducer connected to the low frequency side.
[Transducer Pow-
Set the power of the transducer connected to the high frequency side.
er HF]
[Transducer Pow-
Set the power of the transducer connected to the low frequency side.
er LF]
Motion sensor menu
The [Motion Sensor] menu sets up the motion sensor, which provides for stable dis-
play of the seabed, schools of fish, etc. in moderate-to-rough seas.
Note 1: For connection of NMEA 0183 equipment to the TZT22X/24X, ask your FU-
RUNO dealer to set up the equipment.
Note 2: To use the heaving function, the following settings are required at the satellite
compass. For the setting procedure, see the operator's manual for your satellite com-
pass. Settings for SC-30 are done from the [IF-NMEASC] menu, settings for SC-50/
110 are done from the [DATA OUT] menu.
Sentence
Baud rate
Cycle
PGN
The [MOTION SENSOR] menu appears in the [Transducer Setup] menu when the
[Heaving Correction] is activated in the [Fish Finder] menu. If the satellite compass
SC-30 or SC50/110 is connected, set the distance between the antenna unit (or sen-
sor) of the satellite compass and transducer (high and low if connected) here.
SC-30/33/50/70/110/130
Menu item
[Motion Sensor
Select the sensor connected to your TZT22X/24X unit. For
Type]
all sensors other than SC-50 and SC-110, select [SC-30].
[Antenna Posi-
Set the distance from the antenna unit to the transducer in
tion Bow/Stern
the bow-stern direction. If the transducer is located on the
HF (LF)]
fore side, set a positive value.
[Antenna Posi-
Set the distance from the transducer to the antenna unit in
tion Up/Down HF
the vertical direction. If the transducer is located on the
(LF)]
bow side, set a positive value.
3-18
ATT, HVE
38400BPS
25ms
HF Transducer
HF Transducer
Up/Down
Up/Down
LF Transducer
LF Transducer
Description
Description
NMEA 0183
Heave: 65280
Attitude: 127257
Bow/Stern for HF
Bow/Stern for HF
Port/Starboard for HF
Port/Starboard for HF
Port/Starboard for LF
Port/Starboard for LF
Bow/Stern for LF
Bow/Stern for LF
NMEA 2000
Options
(setting range)
[SC30],
[SC50_SC110]
-99 to +99
-0.00 to +99.9
Advertisement
Table of Contents
