Accessing supervisor level
Programmes
Favourites
Touching the sensor takes you to
the Supervisor level.
Access via code
Supervisor level is accessed using a
code.
Factory default: The code is 000.
Change code
You can alter the Supervisor level ac-
cess code to protect the dryer from
unauthorised access.
Be careful when entering a new code.
You will need to inform Miele Service
if you forget your new code. Miele
Service will have to reset the code.
Make a note of your new code and
store it in a safe place.
Supervisor
Help
Demo programme
11:02
In showrooms, a demo programme
can be started with a simulation.
The programme does not start. The op-
erational sequence is simply a simula-
tion.
Tip: The demo programme will only be
available if a drying programme lasting
more than 1 hour has not been carried
out. After this, the demo programme will
not be available.
Closing the settings menu
Touch the sensor.
The display will then go back to the pre-
vious menu level.
Touch the sensor.
The display will change to the main
menu.
Supervisor level
91