Miele PDR 908 HP Operating And Installation Instructions page 11

Unauthorised repairs could result in unforeseen dangers for the

user, for which Miele cannot accept liability. Repairs should only be
undertaken by a Miele approved service technician, otherwise any
subsequent damage will not be covered by the warranty. Ensure cur-
rent is not supplied to the tumble dryer until after maintenance or re-
pair work has been carried out.
Faulty components must only be replaced by genuine Miele ori-

ginal spare parts. The manufacturer can only guarantee the safety of
the appliance when Miele replacement parts are used.
To ensure the correct performance of the tumble dryer and to pre-

vent the risk of faults and fire, it is important to carry out mainten-
ance on a regular basis.
 In the event of a fault or for cleaning purposes, the tumble dryer is
only completely isolated from the electricity supply when:
- it is switched off at the wall socket or the plug is withdrawn, or
- it is switched off at the mains, or the mains fuse is disconnected
- the screw-out fuse is removed (in countries where this is applic-
able), or it is switched off at the isolator switch.
See "Installation - Electrical connection".
This appliance must not be used in a non-stationary location (e.g.

on a ship).
See "Installation" and "Technical data".

The accessibility of the plug must be always ensured, in order to

separate the tumble dryer from the mains. All electrical work should
be carried out only by a suitably qualified and competent person, in
strict accordance with national and local safety regulations.
If the appliance is hard wired, adequate provision must be made

on site to switch off all poles to disconnect the tumble dryer from the
electrical supply.
Do not block the gap between the bottom of the tumble dryer and

the floor with plinth facings, deep pile carpet etc. This would hinder a
sufficient flow of air to the dryer.
Warning and Safety instructions
11