ZyXEL Communications P-2302HWDL-P1 Support Notes page 6

•
If you have only one computer, connect the computer to the LAN port on the Prestige using a
crossover Ethernet cable (red).
•
If you have more than one computer, you must use a hub or switch to connect the computers to the
LAN port on the Prestige using a straight-though Ethernet cable.
2. TCP/IP Installation
You must first install TCP/IP software on each computer before you can use it for Internet access. If you have
already installed TCP/IP, go to the next section to configure it; otherwise, follow these steps to install the
software:
•
In the Control Panel/Network
•
In the Select Network Component Type
•
In the Select Network Protocol
Network Protocols
3. TCP/IP Configuration
Follow these steps to configure Windows TCP/IP:
•
In the Control Panel/Network
•
In the TCP/IP
Note: Do not assign arbitrary IP address and subnet mask to your computer(s). Otherwise, you will not be able
to access the Internet.
•
Click the WINS
•
Click the Gateway
none listed.
•
Click the DNS Configuration
•
Click OK to save and close the
•
Click OK to close the Network window. You will be prompted to insert your Windows CD or disk.
When the drivers are updated, you will be asked if you want to restart the computer. Make sure
your Prestige is turned on before clicking Yes. Repeat the above steps for each Windows computer
on your network.
•
Setting up the Prestige router
window, click
window, select
field and click OK.
window, select
Properties window, select
configuration tab and select
tab. Select any installed gateways and click the
tab and select
TCP/IP
All contents copyright (c) 2005 ZyXEL Communications Corporation.
Prestige 2302 Support Notes
Add button.
window, select Protocol
Microsoft
TCP/IP and click Properties.
obtain an IP address
Disable WINS Resolution.
Disable DNS.
properties window
and click Add.
and then select TCP/IP
automatically.
Remove button until there is
from the
6