• [ ] [ ]: Move to the next bit.
• [Escape]: Exit without saving changes.
• [Enter]: Exit and save changes.
• The left digit on the display is bit 7 and the right digit is bit 0.
4. Press [Enter] to save changes and exit.
Printer Engine Service Mode
Service Mode Table
Notation
[range / default / step]
Bold
DFU
Japan only
SP1-xxx: Feed
Lead Edge Regist
Adjusts the printing leading edge registration for feeding from the trays and duplex tray
1001
using the trimming area pattern (SP5-902-003 No.9).
Push [ ] or [ ] to select the settings (plus or minus).
The specification is 4±2 mm
Example: [-9 to +9 / 3.0 / 0.1 mm step]. The setting can be adjusted
in the range ±9, value reset to +3.0 after an NVRAM reset, and the
value can be changed in 0.1 mm steps with each key press.
Comments added for reference.
Denotes "Design or Factory Use". Do not change this value.
The feature or item is for Japan only. Do not change this value.
What it means
SP Tables
3
27