Ricoh Gestetner LANIER SAVIN G071 Service Manual page 124

SP MODE TABLES
Mode No.
2
(Class 1, 2, and 3)
924 ITB Cleaning Clutch Off/On
1 Time
2 Number
930* TrimAdjust
1 Front
2 Back
3 Lead
4 Trail
938 OPC Reverse Interval
1 OPC Reverse Interval
939 OPC_Lub_Int
1 OPC_Lub_Int
940 OPC_Lub_Mode
1 OPC_Lub_Mode
941 OPC_Lub_Time
1 job end
2 OPC_Lub_Int
G071
CÓPIA NÃO CONTROLADA
100 ~ 500/ 300 / 10ms /step
0 ~ 5/ 0 / 1 /step
Adjusts the white margin on printouts.
[0 ~ 65535 / 0 / 1/step]
[0 ~ 65535 / 0 / 1/step]
[0 ~ 65535 / 20 / 1/step]
[0 ~ 65535 / 20 / /step]
[0 ~ 100 / 10 / 10 counts /step]
The Main motor rotates the OPC belt backwards for 500
ms at the end of every job, in order to remove foreign
particles between the OPC belt and OPC cleaning blade.
However, this does not need to be performed so often.
In addition, reducing the frequency of OPC belt reverse
rotation improves the cleaning blade performance.
This SP adjusts the counter for the OPC belt reverse
rotation, and is incremented as follows:
LT/A4 LEF or smaller: 1, larger than LT/A4 LEF: 2.
When this SP reaches its set maximum, reverse rotation
is performed for 500ms at job end.
NOTE: Requires main unit controller version 2.27, and
BICU firmware version 1.42 or later.
Executes/does not execute OPC lubrication by
interrupting the job. DFU
[0 ~ 1 / 0 / 1/step]
• 0: Off
• 1: On
SP2-942-1 (OPC_Lub_Intrvl) specifies the lubrication
interval.
Executes a forced OPC lubrication to reduce the friction
on the OPC belt.DFU
[0 ~ 1 / 0 / 1/step]
• The OPC belt and the lubricant brush operate for 2
minutes.
Determines how long the OPC belt is lubricated for after
the end of every job.
[6 ~ 30 / 14 / 1 s/step]
NOTE: Requires main unit controller version 2.28, and
BICU firmware version 1.44A or later.
Determines how long the OPC belt is lubricated at the
forced lubrication. (See NOTE for SP2-941-1)
[6 ~ 60 / 10 / 1 s/step]
5-26
CÓPIA NÃO CONTROLADA
Function / [ Setting ]
Rev. 01/2004
SM