Table of Contents
Advertisement
Result Codes
Result Codes
Result codes are informational messages sent from the modem
and displayed on your monitor. These messages are the
modem's response to commands you issue to the modem. They
can inform you of the status of a call (Ring, No Answer), or
whether or not a command is valid (OK, Error), or whether or
not the modem has connected using error control (Connect
14400 V42/MNP/Bfr).
The KeepInTouch Card modem ships from the factory
configured to use the word format. If your computer requires
that you use the numbers format instead, refer to the Q n , V n ,
and X n commands in Chapter 4.
Table C-1 describes the result codes supported by the
KeepInTouch Card modem.
Table C-1. Result Codes (1 of 3)
Number 1,
Word
Number 2
NOTE: The following result codes are enabled by the X0–X7
commands.
0,0
OK
1,1
CONNECT
2,2
RING
3,3
NO
CARRIER
4,4
ERROR
Description
Command executed
Modem connected to line
Modem receiving a ring voltage from
the VF line
Modem lost carrier signal, does not
detect carrier signal, or does not
detect answer tone
Invalid command
Issue 3 April 1994
C
C-1
Advertisement
Table of Contents
Troubleshooting
