Table D-1. Automatic Cellular Setup Configuration Parameters
Configuration Option
Error Control Mode
Maximum Frame Size
No Carrier Disconnect
V.32 bis Train
V.32 bis Autorate
V.42 ARQ Window Size Window size of 15
Cellular Enhancements Enable
When the modem detects a normal land-line telephone
connection, the parameters in Table D-1 automatically switch
back to their non-cellular settings.
&F5 Cellular Setup for RJ11 Adapter
Connection on the Cellular Side
Use the &F5 command to configure your modem for cellular
operation when the modem is attached to a cellular telephone
through an RJ11 adapter box. This command restores the
modem to its factory default configuration (as if &F0 had been
entered) and then changes specific configuration options for
cellular operation as shown in Table D-2.
Table D-2. &F5 Cellular Setup Configuration
Parameters (1 of 2)
Configuration Option
Error Control Mode
Maximum Frame Size
No Carrier Disconnect
V.32 bis Autorate
V.42 ARQ Window Size Window size of 15
D-4
Issue 3 April 1994
Automatic
Cellular Setting
LAPM or disconnect \N4
32 characters/frame
10 seconds
Short Train
Start at 9600
&F5
Cellular Setting
LAPM or disconnect \N4
32 characters/frame
10 seconds
Start at 9600
AT Command
Equivalent
\A4
S10=100
S43=1
S76=3
S89=9
S91=1
AT Command
Equivalent
\A4
S10=100
S76=3
S89=9