Savi Configuration In Slaac-Only Address Assignment Scenario; Network Requirements; Configuration Considerations - HP 3600 v2 Series Configuration Manual

[SwitchB] interface ethernet 1/0/2
[SwitchB-Ethernet1/0/2] ipv6 verify source ipv6-address mac-address
[SwitchB-Ethernet1/0/2] quit
[SwitchB] interface ethernet 1/0/3
[SwitchB-Ethernet1/0/3] ipv6 verify source ipv6-address mac-address
[SwitchB-Ethernet1/0/3] quit
SAVI configuration in SLAAC-only address
assignment scenario

Network requirements

Figure 135 Network diagram
Switch A
Switch B
Host A
10::5
0001-0203-0405
As shown in
can obtain IPv6 addresses only through SLAAC. Configure SAVI on Switch B to bind the addresses
assigned through SLAAC and permit only packets from the bound addresses.

Configuration considerations

Configure Switch B as follows:
1. Enable SAVI.
2. Enable global unicast address ND snooping and link-local address ND snooping. For more
information about ND snooping, see Layer 3—IP Services Configuration Guide.
3. Enable ND detection in VLAN 10 to check the ND packets arrived on the ports. For more
information about ND detection, see
Internet
Gateway
Eth1/0/3
Vlan-int10
10::1
VLAN 10
Eth1/0/3
Eth1/0/1 Eth1/0/2
0001-0203-0607
Figure 135, Switch A serves as the gateway. Switch B connects Host A and Host B. The hosts
Host B
10::6
"Configuring ND attack
417
defense."