HP 3600 v2 Series Configuration Manual page 226

Intrusion Protection mode is NoAction
Max MAC address number is not configured
Stored MAC address number is 0
Authorization is permitted
Security MAC address learning mode is sticky
Security MAC address aging type is absolute
After an 802.1X user gets online, you can see that the number of secure MAC addresses stored is 1.
# Display 802.1X information.
<Device> display dot1x interface ethernet 1/0/1
Equipment 802.1X protocol is enabled
CHAP authentication is enabled
EAD quick deploy is disabled
Configuration: Transmit Period
Quiet Period
Supp Timeout
Reauth Period
The maximal retransmitting times
EAD quick deploy configuration:
EAD timeout:
The maximum 802.1X user resource number is 2048 per slot
Total current used 802.1X resource number is 1
Ethernet1/0/1 is link-up
802.1X protocol is enabled
Handshake is enabled
Handshake secure is disabled
802.1X unicast-trigger is enabled
Periodic reauthentication is disabled
The port is an authenticator
Authentication Mode is Auto
Port Control Type is Mac-based
802.1X Multicast-trigger is enabled
Mandatory authentication domain: NOT configured
Guest VLAN: NOT configured
Auth-Fail VLAN: NOT configured
Critical VLAN: NOT configured
Critical recovery-action: NOT configured
Max number of on-line users is 2048
EAPOL Packet: Tx 16331, Rx 102
Sent EAP Request/Identity Packets : 16316
EAP Request/Challenge Packets: 6
EAP Success Packets: 4, Fail Packets: 5
Received EAPOL Start Packets : 6
EAPOL LogOff Packets: 2
EAP Response/Identity Packets : 80
30 s, Handshake Period
60 s, Quiet Period Timer is disabled
30 s, Server Timeout
3600 s
30m
213
15 s
100 s
2