HP 3600 v2 Series Configuration Manual page 26

No. Attribute
31 Calling-Station-Id
32 NAS-Identifier
40 Acct-Status-Type
45 Acct-Authentic
60 CHAP-Challenge
61 NAS-Port-Type
79 EAP-Message
Message-Authentic
80
ator
87 NAS-Port-Id
HP proprietary RADIUS sub-attributes
No. Sub-attribute
1 Input-Peak-Rate
2 Input-Average-Rate
3 Input-Basic-Rate
Description
User identification that the NAS sends to the server. For the LAN access service
provided by an HP device, this attribute carries the MAC address of the user in
the format HHHH-HHHH-HHHH.
Identification that the NAS uses for indicating itself.
Type of the Accounting-Request packet. Possible values are as follows:
•
1—Start.
•
2—Stop.
•
3—Interim-Update.
•
4—Reset-Charge.
•
7—Accounting-On. (Defined in 3GPP, the 3rd Generation Partnership
Project.)
•
8—Accounting-Off. (Defined in 3GPP.)
•
9 to 14—Reserved for tunnel accounting.
•
15—Reserved for failed.
Authentication method used by the user. Possible values are as follows:
•
1—RADIUS.
•
2—Local.
•
3—Remote.
CHAP challenge generated by the NAS for MD5 calculation during CHAP
authentication.
Type of the physical port of the NAS that is authenticating the user. Possible
values are as follows:
•
15—Ethernet.
•
16—Any type of ADSL.
•
17—Cable (with cable for cable TV).
•
19—WLAN-IEEE 802.1 1.
•
201—VLAN.
•
202—ATM.
If the port is an ATM or Ethernet one and VLANs are implemented on it, the value
of this attribute is 201.
Used for encapsulating EAP packets to allow the NAS to authenticate dial-in
users via EAP without having to understand the EAP protocol.
Used for authentication and checking of authentication packets to prevent
spoofing Access-Requests. This attribute is used when RADIUS supports EAP
authentication.
String for describing the port of the NAS that is authenticating the user.
Description
Peak rate in the direction from the user to the NAS, in bps.
Average rate in the direction from the user to the NAS, in bps.
Basic rate in the direction from the user to the NAS, in bps.
13