Configuration Example - HP 3600 v2 Series Configuration Manual
Hide thumbs
Also See for 3600 v2 Series:
- Command reference manual (510 pages) ,
- Configuration manual (441 pages) ,
- Security configuration manual (398 pages)
Table of Contents
Advertisement
Step
1.
Enter system view.
2.
Enter Layer 2 Ethernet interface
view/Layer 2 aggregate interface
view.
3.
Configure an ARP filtering entry.
Configuration example
Network requirements
As shown in
and MAC addresses of Host B are 10.1.1.3 and 000f-e349- 1 234.
Configure ARP filtering on Ethernet 1/0/1 and Ethernet 1/0/2 of Switch B to permit specific ARP
packets only.
Figure 122 Network diagram
Configuration procedure
# Configure ARP filtering on Switch B.
<SwitchB> system-view
[SwitchB] interface ethernet 1/0/1
[SwitchB-Ethernet1/0/1] arp filter binding 10.1.1.2 000f-e349-1233
[SwitchB-Ethernet1/0/1] quit
[SwitchB] interface ethernet 1/0/2
[SwitchB-Ethernet1/0/2] arp filter binding 10.1.1.3 000f-e349-1234
After the configuration is complete, Ethernet 1/0/1 will permit incoming ARP packets with sender IP and
MAC addresses as 10.1.1.2 and 000f-e349- 1 233, and discard other ARP packets. Ethernet 1/0/2 will
permit incoming ARP packets with sender IP and MAC addresses as 10.1.1.9 and 000f-e349- 1 233 and
discard other ARP packets. ARP packets from Host A are permitted, but those from Host B are discarded.
Figure
122, the IP and MAC addresses of Host A are 10.1.1.2 and 000f-e349- 1 233. The IP
Command
system-view
interface interface-type
interface-number
arp filter binding ip-address
mac-address
391
Remarks
N/A
N/A
Not configured by default
Advertisement
Table of Contents
Troubleshooting
