HP 3600 v2 Series Configuration Manual page 425
Hide thumbs
Also See for 3600 v2 Series:
- Command reference manual (510 pages) ,
- Configuration manual (441 pages) ,
- Security configuration manual (398 pages)
Table of Contents
Advertisement
Figure 133 Network diagram
Configuration procedure
1.
Configure IP addresses of the hosts, as in shown in
2.
Configure the IP address of VLAN-interface 1 on the gateway.
<Gateway> system-view
[Gateway] interface Vlan-interface 1
[Gateway-Vlan-interface1] ip address 10.1.1.100 24
3.
Configure Switch A:
# Enable STP.
[SwitchA] stp enable
# Configure manual-mode MFF.
[SwitchA] vlan 100
[SwitchA-vlan-100] mac-forced-forwarding default-gateway 10.1.1.100
# Specify the IP address of the server.
[SwitchA-vlan-100] mac-forced-forwarding server 10.1.1.200
# Enable ARP snooping.
[SwitchA-vlan-100] arp-snooping enable
[SwitchA-vlan-100] quit
# Configure Ethernet 1/0/2 and Ethernet 1/0/3 as network ports.
[SwitchA] interface ethernet 1/0/2
[SwitchA-Ethernet1/0/2] mac-forced-forwarding network-port
[SwitchA-Ethernet1/0/2] quit
[SwitchA] interface ethernet 1/0/3
[SwitchA-Ethernet1/0/3] mac-forced-forwarding network-port
4.
Configure Switch B:
# Enable STP.
[SwitchB] stp enable
# Configure manual-mode MFF.
[SwitchB] vlan 100
[SwitchB-vlan-100] mac-forced-forwarding default-gateway 10.1.1.100
# Specify the IP address of the server.
Figure
133.
412
Advertisement
Table of Contents
Troubleshooting
