HP 3600 v2 Series Configuration Manual page 190
Hide thumbs
Also See for 3600 v2 Series:
- Command reference manual (510 pages) ,
- Configuration manual (441 pages) ,
- Security configuration manual (398 pages)
Table of Contents
Advertisement
Figure 62 Network diagram
Configuration considerations
1.
Configure the portal server and enable portal server heartbeat function and the portal user
heartbeat function.
2.
Configure the RADIUS server to implement authentication and accounting.
3.
Configure direct portal authentication on interface VLAN-interface 100, which is connected with
the user host.
4.
Configure the portal server detection function on the access device, so that the access device can
detect the status of the portal server by cooperating with the portal server heartbeat function.
5.
Configure the portal user information synchronization function, so that the access device can
synchronize portal user information with the portal server by cooperating with the portal user
heartbeat function.
Configure IP addresses for the host, switch, and servers as shown in
can reach each other.
Configure the RADIUS server properly to provide authentication and accounting functions for users.
Configuring the portal server (IMC PLAT 5.0)
This example assumes that the portal server runs IMC PLAT 5.0(E0101) and IMC UAM 5.0(E0101).
# Configure the portal server.
Log in to IMC and select the Service tab. Then, select User Access Manager > Portal Service
Management > Server from the navigation tree to enter the portal server configuration page, as shown
in
Figure
63.
Configure the portal server heartbeat interval and user heartbeat interval.
•
Use the default value for other parameters.
•
177
Figure 62
and make sure that they
Advertisement
Table of Contents
Troubleshooting
