9.3.8
Correcting lighting faults
Symptom
Cause
The front light or rear light
The default settings in the electric drive
does not go on, even
system have probably been configured
when the switch is
incorrectly. The light is defective.
pressed.
Table 56: Lighting fault solution
9.3.9
Correcting faults in tyres
Symptom
Cause
Presta valve used with a sizeable valve
Valve torn off.
hole. The hole's metal edge separates
the valve stem from the tube.
Table 57: Fault solution for tyres
9.3.10 Correcting control seat post faults
Symptom
Cause
Seat post clicks or creaks. Protective layer missing.
Seat post deflects and
Incorrect preload.
bobs periodically.
Seat post with remote
Bowden cable is not tensioned
control does not rise or
correctly.
lower.
Table 58: Fault solution for the seat post
MY23I0a - 42_1.0_22.01.2024
Troubleshooting, fault clearance and repair
Remedy
1
Take pedelec out of service immediately.
2
Contact specialist dealer.
Remedy
Contact specialist dealer. Fit another type of valve.
Remedy
Service seat post (see Section 7.4.9).
Adjust preload so that the suspension seat post does not
compress under the rider's weight when at rest.
Adjust the Bowden cable with the setting screw (1) on the
remote control.
1
Figure 223: Remote control with setting screw (1)
•
Reduce sensitivity: turn the setting screw clockwise.
•
Increase sensitivity: turn setting screw anti-clockwise.
262