Table of Contents
Advertisement
Check if the transmitter frequency of the
#
remote control has the frequency range of
280 to 868 MHz.
Radio equipment approval number:
NZLMUAHL5 (USA)
R
4112A-MUAHL5 (Canada)
R
Press and hold button 1,
2
or
#
wish to program.
Indicator lamp
4
flashes yellow.
%
It can take up to 20 seconds before the indi-
cator lamp flashes yellow.
Release the previously pressed button.
#
Indicator lamp
4
continues to flash yellow.
Point remote control
5
from a distance of
#
0.4 in (1 cm) to 3 in (8 cm) towards button
1,
2
or 3.
Press and hold button
6
of remote control
#
5
until one of the following signals appears:
Indicator lamp
4
lights up green continu-
R
ously. Programming is complete.
Indicator lamp
4
flashes green. Program-
R
ming was successful. Additionally, syn-
chronization of the rolling code with the
door system must be carried out.
If indicator lamp
4
does not light up or flash
#
green: repeat the procedure.
Release all of the buttons.
#
3
that you
%
The remote control for the door drive is not
included in the scope of delivery of the garage
door opener.
▌Synchronizing the rolling code
Requirements
The door system uses a rolling code.
R
The vehicle must be within range of the garage
R
door or door drive.
The vehicle as well as persons and objects are
R
located outside the range of movement of the
door.
Press the program button on the door drive
#
unit.
Initiate the next step within approximately
30 seconds.
Press previously programmed button 1,
#
or
3
repeatedly until the door closes.
When the door closes, programming is com-
pleted.
%
Please also read the operating instructions for
the door drive.
Driving and parking 183
2
Advertisement
Table of Contents
