Table of Contents
Advertisement
150 Driving and parking
In the event of an accident or impact to the
vehicle underbody, components of the high-
voltage electrical system may be damaged
although the damage is not visible.
Never make any modifications to the
#
high-voltage on-board electrical system.
Do not switch on or use the vehicle if its
#
high-voltage on-board electrical system
components have been modified or dam-
aged.
Never touch damaged components of
#
the high-voltage on-board electrical sys-
tem.
After an accident, do not touch any com-
#
ponents of the high-voltage on-board
electrical system.
After an accident, have the vehicle trans-
#
ported away.
Have the components of the high-voltage
#
on-board electrical system checked at a
qualified specialist workshop and
replaced if necessary.
Requirements
Only disconnect the high-voltage on-board electri-
cal system manually in the following situations:
The 6 restraint system warning lamp lights
R
up in the Instrument Display, e.g. after an
accident.
The vehicle is badly damaged, e.g. after an
R
accident, and the restraint system compo-
nents have not been triggered.
Operating the high-voltage disconnect device
Only disconnect the high-voltage on-board electri-
cal system manually in the above-mentioned sit-
uations.
Switch off the vehicle.
#
Shift the transmission to position j.
#
Apply the electric parking brake.
#
Secure the vehicle against rolling away.
#
Open the hood.
#
Press release tab
1
in the direction of the
#
arrow and pull it out.
Pull high-voltage disconnect device
#
direction of the arrow until it engages.
The high-voltage on-board electrical system is
switched off.
All work on the drive system (including after dis-
connecting the high-voltage on-board electrical
2
in the
Advertisement
Table of Contents
