Yaesu FT-2000 Operating Manual page 6

P R
LEASE EAD
When turning on the transceiver for the first time, please set the local time as soon as possible. If this is not done, the
various functions of the World Clock and Great Circle Map will not function correctly.
Note: If you wish to add a city to the City List that was programmed at the factory, you will need to supply your own USB
or PS/2 Keyboard. If you utilize one of the pre-loaded cities, a keyboard is not necessary.
You may also set up the local time for other locations, without a keyboard, using the cities that have been pre-loaded at
the factory.
Please note that there are four power switches that must be turned on in order for the operation. They are (1) main power
switch of the transceiver, (2) actual power switch of the transceiver, (3) main power switch of the Data Management
Unit, and (4) actual power switch of the Data Management Unit. This Data Management Unit must be turned on before
pressing the power switch on the front panel of the transceiver.
1. T T
To turn the transceiver on, first press the
main [ POWER ] switch (so that the " "
side is pressed downward). In the FT-
2000 (100 W version), the main [ POWER ] switch is
on the right side of the rear panel. For the FT-2000D
(200 W version), the Main [ POWER ] switch is lo-
cated on the front panel of the FP-2000.
Hold in the front panel [ POWER ] switch
to turn the transceiver on.
2. T DMU-2000 O
To turn the Data Management Unit on,
first press the main [ POWER ] switch (so
that the " " side is pressed downward) on
the rear panel, then press the front panel
[ POWER ] switch to turn the Data Man-
agement Unit on.
Note: The opening screen will appear on the after-mar-
ket monitor and the self-check function of the CPU in-
side the Data Management Unit will begin. When the Data
Management Unit is turned on for the first time, it takes
about 50 seconds (for self- checking) until the Data Man-
agement Unit becomes ready to use; however, from the
next time you turn it on, it will take around 10 seconds
until the Data Management Unit is ready for full opera-
tion.
Note
In the discussion to follow, reference will be made
to various "Function" keys (for example,
[ F1 ( MAP )] ). This nomenclature refers to the
[ F1 ( CH-1 )] ~ [ DISPLAY ] keys located along the
bottom left edge of the front panel of the FT-2000.
The exact function of each key will depend upon
the "Page" of the display being viewed on the
monitor; therefore, when using the World Map
page, [ F1 ( MAP )] represents the pressing of the
[ F1 ( CH-1 )] key, with "MAP" being the function
appearing in the "F1" position at the bottom edge
of the monitor screen.
Page 4
T F
HIS IRST
O 3. L T S
If you press and hold in the [ DISPLAY ] key for more
than two seconds, white letters will appear at the bot-
tom of the screen to indicate various functions, and
the FT-2000's [ F1 ( CH-1 )] ~ [ F7 ( P.BACK )] and [ DIS-
PLAY ] keys will act as "Function" keys.
On the monitor, there should be a World Map dis-
played; if the World Map does not appear, find the
[ F1 ( MAP )] key on the front panel of the FT-2000;
press this key to get the World Map to display on the
monitor.
F
UNCTION
Press the [ DISPLAY ] key to change the action of the
"Function" keys, then press the [ F1 ( SET )] key; the
monitor should now show "LOCAL TIME-1;" this set-
ting has been pre-set for Japanese time at the factory.
DMU-2000 D
T
ABS
M U