Using The Menu Mode - Yaesu FT-2000 Operating Manual

U
SING THE
When you want to change something in a menu mode setting, follow the procedure described below.
1. Press the [ MENU ] button momentarily.
The monitor will display the Menu page. Included on
this page will be the Menu Group, Menu Item Name,
Menu Item Number, and the current status (setting)
for each Menu item.
2. Use the Main Tuning Dial, or the the [ F6 ( )] / [ F7 ( )]
keys, to select the Menu item you wish to work on.
3. Use the [ SUB VFO-B ] knob, or the [ F4 ( )] / [ F5 ( )]
keys, to change the setting of the selected Menu item.
4. Press and hold the [ MENU ] button for 2 seconds to
save (within the transceiver) the new setting; the menu
screen will close, and you will then return to the screen
that was in use before entering the menu mode.
If you press the [ MENU ] button momentarily to exit,
the new settings will not be saved, and you will exit
from the menu mode without retaining the new con-
figuration.
It is possible to reset (only) the Menu mode set-
tings back to their factory default. Do this if you
want to clear all settings out, and start fresh with
the original values.
1. Turn off the radio.
2. Turn the radio on while pressing and holding
in the [ MENU ] button.
Page 52
M M
ENU ODE
M M C
ENU ODE ONFIGURATION
M
C
HANGES
M R
[ POWER ] Switch
DMU-2000 D
M P
[ MENU ] Button
M U