Saving Log Data - Yaesu FT-2000 Operating Manual

L B
OG OOK
Log data can be saved in the supplied Compact Flash (CF) card.
1. Referring to Figure
[ F7 ( SAVE/LOAD )] key to move to the Save/Load
page.
2. Press the [ F5 ( SAVE/LOAD )] key to choose the
"Save" protocol.
3. Input the desired FILE NAME, and press the [ F6 ( GO )]
key to save the data in the CF card.
Note: Be sure not to delete the "extension" to the file
name, when entering the file name. If the extension is
missing, it will not be possible to load log data.
When the ERROR message "CF CARD IS NOT READY"
appears on the display, please confirm that the CF card is
inserted correctly into its slot.
When memory data is saved in the CF card, any file with
the same name as the current file will be revised (over-
written), and the previous data will be deleted. Please
note.
You may load log data from a CF card into your DMU-2000 (for example, an archive copy, or a log from a different
DMU-2000 or FT 9000 Series Trasnceiver). Before starting, be sure the CF card containing the log data has been
DX
inserted into the CF Card Slot.
1. Referring to Figure
[ F7 ( SAVE/LOAD )] key to engage the Save/Load
mode.
2. Press the [ F5 ( SAVE/LOAD )] key to engage the
LOAD protocol.
3. Use the [ F1 ( )] and [ F2 ( )] keys to select the file
you wish to upload to the transceiver, then press the
[ F6 ( GO )] key to load the file.
Advice: Be sure not to delete the "extension" to the file
name, when entering the file name. A missing extension
will make it impossible to load log data
When the ERROR message "CF CARD IS NOT READY"
appears on the display, please confirm that the CF card is
inserted correctly into its slot.
When memory data is loaded from the CF card, the cur-
rent memories stored in the DMU-2000 will be over-
written, and the previous data is erased. We recommend
that you save and download the current memory data to
the CF card, if you want to use it again later.
Page 36
F
UNCTION
S
AVING
on page 29, press the
L L
OADING OG
on page 29, press the
L D
OG ATA
"S
Advice: The user configuration protocol (CONFIG) al-
lows you to specify the file format that is used for saving
log data. The available formats are:
ADIF (International Log Format) ............................. adi
CSV (Cursor-Limited Values) ................................. csv
TXT (Tab-Limited Values) ....................................... txt
CABRILLO (International Log Format) .... cabrillolog
D LOAD
ATA
"S
DMU-2000 D
/L " M
/L " M
M U