Yaesu FT-2000 Operating Manual page 25

U
Miscellaneous Functions
S S
U P S
1. Press the [ F1 ( FUNC )] key to show the screen for
setup of the Marker.
2. Press the [ F4 ( P.SRCH )] key to move the marker to
the highest peak signal frequency. With each press the
[ F4 ( P.SRCH )] key, the Marker will shift to the stron-
gest signal frequency away from the current frequency.
C T
1. Press the [ F1 ( FUNC )] key to show the screen for
setup of the Marker.
2. Press the [ F6 ( TRACE )] key to select the Trace mode
of the Spectrum Scope.
The Trace mode selections are shown below.
NORMAL AVERAGE
PEAK HOLD
NORMAL: The real-time signal strength will be
displayed. Normally, you will want to
use this mode.
AVERAGE: The averaged signal strength will be
displayed.
PEAK HOLD: The signal level will be displayed, with
peak strengths held for a few seconds.
If the QMB frequency is within the Spectrum Scope
sweep range, the QMB channel's frequency will be
displayed on the screen by a white arrow ( ) .
You may remove the QMB Marker from the screen
via menu item "014 diSP QMB MARKER," if de-
sired.
DMU-2000 D M
CTR C
SING THE
S
F
NORMAL ......
QMB M
U
S
PECTRUM
D
ENTER ISPLAY
[ F4 ( P.SRCH )] Key
QMB Marker
S
COPE
M
ODE
[ F6 ( TRACE )] Key
Page 23