Log Book Data Input - Yaesu FT-2000 Operating Manual

L B
OG OOK
Log data may be entered by the user. Depending on the user setup (CONFIG) for "LOGGING TYPE," there are two
logging modes: In the "CONTEST" mode, the operator just enters the callsign, signal report, and the REM ("remarks")
fields, and the Date/Time/Band/Mode are all entered automatically. In the "NORMAL" mode, additional information
may be entered, such as the Country, City, and Name. Up to 500 stations may store into a file.
Please enter the log data in accordance with the example in the illustration.
Advice: Before you start logging, we recommend that you perform the CONFIG SETTING MODE procedure within
the User setup (CONFIG) protocol.
1. Referring to the Figure
board to enter the callsign in the "CALL" field. Now
press the keyboard's [ ENTER ] key.
2. The callsign will be checked against the previous en-
tries to see if it is a duplicate; if so, the "CALLSIGN
REPETITION CHECKLIST" will open, listing this
and any other duplicates. During the QSO, if you wish
to delete the callsign and other information for this
line, just press the keyboard's [ ESC ] key.
3. Enter all desired data in accordance with the example
in the picture. When finished, press the keyboard's
[ ENTER ] key.
Note: In order to ensure preservation of log data, be sure
to Save the data frequently. It is always a good idea to
maintain a paper archive copy of log data. Vertex Stan-
dard specifically disclaims responsibility for any liabil-
ity arising from the loss of log data.
Page 34
F
UNCTION
L B
OG OOK
on page 29, use your key-
D I
ATA NPUT
C
Advice: When entering the Zone via the "ITUZ
pressing the key-board's [ ENTER ] key will move you to
the CQ Zone (CQZ ); from there, use the key-board's
R
[ ] key to navigate back to the "ITUZ
When doing input of the "PREFIX," "CQZ
"ENTITY," and "QRA" data, please set the "LOGGING
TYPE" to "NORMAL" beforehand. This will allow you
to move from column to column by pressing the key-
board's [ ENTER ] key. In addition, when (for example)
entering the "PREFIX" and pressing the key-board's [ EN-
TER ] key, the "PREFIX SELECT LIST" will appear, and
the "ENTITY" and "CQZ
cally be entered.
DMU-2000 D
R C L
" field,
R
" field, if desired.
R
" (or "ITUZ
R
" (or "ITUZ ") will automati-
R R
M
"),
R
U