Table of Contents
Advertisement
Fuse Replacement
If your SMOKEFIRE grill is non-responsive even after securing all electrical
connections, it is possible that the grill's fuse has blown. The grill's power
supply utilizes a cartridge fuse. This simple and inexpensive part can be easily
replaced with the following instructions:
CAUTION: Only use the properly sized and rated fuse when replacing. Failure to do
so will void your warranty. The correct fuse is:
5A
250V
5x20mm
Fast blow
1. Make sure that the grill is completely cool, then power off and unplug the
grill from the power source (A).
2. The fuse is installed inside the fuse holder located on the underside of
the hopper. Use a flathead screwdriver to gently pry open the fuse holder
and remove the fuse (B).
NOTE: WEBER recommends replacing the fuse if there is suspicion of failure.
3. Install a new fuse into the fuse holder and reinstall the fuse holder into
the power module (C).
CAUTION: Make sure the fuse holder is fully installed and closed before operating
your grill.
4. Plug in, power on the grill, and begin a cook to allow the controller to run
diagnostics.
CALL
CUSTOMER
SERVICE
If you are still experiencing any
problems, contact the Customer Service
Representative in your area using
the contact information on
weber.com.
REPLACEMENT
PARTS
To obtain replacement parts,
contact the local retailer
in your area or log onto weber.com.
TROUBLESHOOTING
A
B
C
37
weber.com
Advertisement
Table of Contents
