Weber SmokeFire SEAR+ ELX4 Owner's Manual page 22

TROUBLESHOOTING
Error Code
E4
E5
22
Cause
Communication Failure
(NOTE: This notification will only
be seen in the app.)
Grill is too Hot
1. The grill will automatically run the shutdown procedure if the grill is still hot. Open
the grill lid and wait until the grill has completed the shutdown procedure and
completely cooled.
CAUTION: Do not unplug the grill or power it off during the shutdown procedure.
2. Once the shutdown procedure is complete, power off the grill and unplug from
power source.
3. Wait one minute, then plug the grill back into the power source and power on the
grill to begin your cook.
1. The grill will automatically run the shutdown procedure if the grill is still hot. Keep
the grill lid closed and wait until the grill has completed the shutdown procedure
and completely cooled.
CAUTION: Do not unplug the grill or power it off during the shutdown procedure.
2. Once the shutdown procedure is complete, power off the grill and unplug from
power source.
3. Open the grill lid and remove the cooking grates, FLAVORIZER bars, heat diffuser,
and heat baffle from the cookbox.
4. Clean the cookbox and burn pot of any ash or debris using a grill brush or scraper to
direct it into the ash and grease system.
CAUTION: Allow time for the ash and debris to fully extinguish before cleaning the grill.
5. Reinstall the heat baffle, heat diffuser, FLAVORIZER bars and cooking grates inside
the cookbox.
6. Remove and clean any ash or grease from inside the ash and grease system. Once
cleaned, reinstall the drawer. Replace disposable drip pans as needed.
7. Plug the grill into the power source and power on the grill to begin your cook.
Solution