Weber SmokeFire SEAR+ ELX4 Owner's Manual page 23

Error Code
E6
E7
E8
E9 Low Fuel Detection Error
Cause
1. The grill will automatically run the shutdown procedure if the grill is still hot. Open
CAUTION: Do not unplug the grill or power it off during the shutdown procedure.
2. Once the shutdown procedure is complete, power off the grill and unplug from
3. Open the grill lid and remove the cooking grates, FLAVORIZER bars, heat diffuser,
4. Clean the cookbox and burn pot of any ash or debris using a grill brush or scraper to
CAUTION: Allow time for the ash and debris to fully extinguish before cleaning the grill.
5. Remove and clean any ash or grease from inside the ash and grease system. Once
6. Plug the grill into the power source and power on the grill.
Start Up Failure
7. Turn and push the dial on the controller to select 400°F as your grill temperature.
8. As the grill starts to preheat, visually inspect the glow plug at the bottom of the
WARNING: Do not touch the glow plug to check if it is hot. If the glow plug is operating
correctly, it will start to glow in color as it heats.
If the glow plug is operating correctly:
9. Reinstall the heat baffle, heat diffuser, FLAVORIZER bars and cooking grates inside
NOTE: If you continue to experience start up failure, empty the hopper using the pellet slide
door and check for any obstructions at the auger.
If the glow plug is not operating correctly:
• The grill will remain cool and will not ignite. Shutdown the grill by pressing and holding
the dial on the controller. Contact the Customer Service Representative in your area
using the contact information on our website for glow plug replacement.
The grill will automatically run the shutdown procedure if the grill is still hot. Open the
grill lid and wait until the grill has completed the shutdown procedure and completely
cooled.
CAUTION: Do not unplug the grill or power it off during the shutdown procedure.
Motor Failure
See the following instructions on how to check the motor's electrical connection. If the
motor is not operating after securing the motor connection, contact the Customer Service
Representative in your area using the contact information on our website for motor
replacement.
The grill will automatically run the shutdown procedure if the grill is still hot. Open the
grill lid and wait until the grill has completed the shutdown procedure and completely
cooled.
Thermocouple Error
CAUTION: Do not unplug the grill or power it off during the shutdown procedure.
Contact the Customer Service Representative in your area using the contact information
on our website to replace the thermocouple.
The grill will automatically run the shutdown procedure if the grill is still hot. Open the
grill lid and wait until the grill has completed the shutdown procedure and completely
cooled.
CAUTION: Do not unplug the grill or power it off during the shutdown procedure.
See the following instructions on how to clean the low fuel sensor window. If the low
fuel sensor is not operating properly after cleaning, contact the Customer Service
Representative in your area using the contact information on our website for low fuel
sensor replacement.
TROUBLESHOOTING
Solution
the grill lid and wait until the grill has completed the shutdown procedure and
completely cooled.
power source.
and heat baffle from the cookbox.
direct it into the ash and grease system.
cleaned, reinstall the drawer. Replace disposable drip pans as needed.
cookbox.
the cookbox.
23
weber.com