Configure Netware Settings N - Xerox WorkCentre M24 System Administrator Manual

Configure NetWare Settings
Configure NetWare Settings
1.
Open your Web browser and enter the TCP/IP address of the Printer in the Address or Location field.
Press Enter.
2.
Click the Properties button or Tab.
3.
Click the plus symbol (+) to the left of the Protocol Settings file folder.
4.
Select NetWare in the directory tree.
5.
The available selections include:
A Host Name (Print Server) Text box. Use this name to create the Print Server (in Bindery) and Print
Server object (in NDS).
An Active Mode selection box for Directory (NDS) or Bindery.
A Primary File Server name entry box (Bindery).
A Poll Interval entry box for Queue Polling Interval (1 - 1000 seconds).
A Number of Search entry box for SAP frequency (1 - 100 seconds, with the ability to set to zero, which
is off).
Two Password text boxes for logging into the NetWare Server.
A TBCP Filter checkbox (displayed when PostScript is enabled).
Under the NDS Subject Label there is a text box for NDS Tree, followed by one for NDS Context.
A Frame Selection box, with a default of Auto sensing. Other selections include Ethernet II (used when
running TCP/IP on your network), Ethernet 802.3 (used for NetWare versions up to 3.11), Ethernet
802.2 (the default for NetWare 3.12 and later), and Ethernet SNAP (used on networks running TCP/IP
and/or AppleTalk).
A display of the Printer's Network (MAC) address.
A Service Location Protocol (SLP) Active Search Enablement box. For use with NetWare 5 and newer
versions, this protocol helps to reduce service advertising network traffic.
6.
Either accept the default Host (Print Server) Name or type in a new name that matches the name used
on the Server.
7.
Select the type of NetWare network (Mode) that applies to your situation.
8.
If setting up this printer in a Bindery environment, provide the name of the Primary Server.
9.
Enter in a polling rate for Poll Interval (Queue Polling Interval).
10.
Enter in a SAP (service advertising protocol) frequency, or set Number of Search (SAP frequency) to
zero (off).
11.
Type a Password for the Printer to log into the NetWare Server, and type it a second time for
confirmation.
12.
For NetWare NDS (NetWare Directory Services), type a directory tree and context (typeful name for the
Printer in the NDS environment). Note: Since there is no Browse function, you MUST manually enter in
this information. For example: O=xerox.OU=engineering.
13.
For Frame Selection, if in doubt, leave the setting at its Auto sensing default value.
14.
Click the Apply New Settings button, then click the Reboot button to reboot the Printer and apply
setting changes.
N5.2