Xerox WorkCentre M24 System Administrator Manual page 87

5e1 - Microsoft (NetBIOS over IP) Networks
16.
Exit the Ports and Protocols selection screen by pressing the rectangular Close button in the upper
right corner of the screen.
17.
Exit the screen containing the Network Settings button by pressing the rectangular Close button in the
upper right corner of the screen.
18.
Finally, press the rectangular Exit button in the upper right corner of the four-button, System Settings
screen to have the printer reboot and enable your SMB setting.
Viewing or Configuring the SMB Host Name with Internet Services
1.
Open your Web browser and enter the TCP/IP address of the Printer in the Address or Location field.
Press Enter.
2.
Click the Properties button or Tab.
3.
Click the plus symbol (+) to the left of the Protocol Settings file folder.
4.
Select SMB in the directory tree.
5.
The available selections include:
A text box indicating Workgroup name.
A text box indicating the SMB Host name.
A text box indicating the Administrator name.
A text box indicating the Administrator Password.
A text box confirming the Administrator Password.
An entry box for the maximum number of connections allowed, labeled Maximum Sessions.
A TBCP Filter checkbox (displayed when PostScript is enabled).
An enabling checkbox for Auto Driver Download, enabling the Printer to push a driver to a client.
An enabling checkbox for supporting Unicode (supplying the Host name and Workgroup name in
Unicode characters during SMB transmission).
An enabling checkbox for Auto Master Mode.
An enabling checkbox for Encrypt Password (during SMB transmission).
6.
Either accept the default SMB Host Name, which is automatically built by the Printer to assure the
name's uniqueness, or enter in your preferred name. Note that this will be the NetBIOS name that is
resolved by the Naming Server (DNS or WINS) to an IP Address for the Printer.
7.
To apply setting changes, click the Apply New Settings button, then click the Reboot button to reboot
the printer. To exit without making any changes, click the Restore Settings button.
DNS/WINS NetBIOS Name Resolution
To use the Printer's NetBIOS name over the TCP/IP Network, the DNS and WINS Servers MUST be configured
for NetBIOS name to IP address resolution. Also, make sure that the Printer is informed of the addresses of the
DNS/WINS Servers, using the instructions supplied under the Configure TCP/IP Settings procedure in the
Internet Services section of this guide.
To Set Up a Workstation to Print Directly to the Printer
Refer to the setup instructions supplied for NetBIOS over IP Peer to Peer Printing under the Print Drivers
Tab of this guide or, if you are an EXPERIENCED SYSTEM ADMINISTRATOR, perform the following steps: