Table of Contents
Advertisement
Display Orientation
To set which way the display faces, follow the instructions below:
1. Go to the Setup main level.
2. Select Screen Reverse.
3. Select NO (display is normal), YES (display is inverted), or AUTO (the display automatically
detects which way the product is facing and orients itself accordingly).
Tilt Angle Range
To set the range of motion the tilt is permitted, do the following:
1. Go to the Setup main level.
2. Select Tilt Angle.
3. Select 200 (200° tilt), 180 (180° tilt), or 60 (60° tilt).
Blackout on Tilt Movement
To set whether the product will black out during tilt movement, follow the instructions below:
1. Go to the Setup main level.
2. Select BL. O. T Move.
3. Select NO (do not black out) or YES (black out during movement).
Backlight Timer
To set the amount of time after inactivity before the display backlight turns off, do the following:
1. Go to the Setup main level.
2. Select Backlight Timer.
3. Select 30S (after 30 seconds of inactivity), 1M (after 1 minute of inactivity), 5M (after 5 minutes of
inactivity), or ON (does not turn off).
Loss of Data
In case of any loss of input signal, the COLORado PXL Curve 12 will respond in one of two ways: The
product will either hold the last signal received, or black out all LED output.
To set how the product responds, follow the instructions below:
1. Go to the Setup main level.
2. Select Loss of Data.
3. Select Hold (hold last signal received) or Close (black out all LED output).
Color-Mixing Mode
The COLORado PXL Curve 12 has a mode that emulates CMY (cyan, magenta, and yellow) color mixing.
In this mode, the dimming is reversed (000 = 100%, 255 = 0%), and the red, green, and blue channels
control cyan, magenta, and yellow, respectively.
To set the color-mixing mode, do the following:
1. Go to the Setup main level.
2. Select C Mixing Mode.
3. Select RGBW (additive mode: 0–100%) or CMY (subtractive mode: 100–0%).
Dimmer Curve
To set the dimmer curve, follow the instructions below:
1. Go to the Setup main level.
2. Select Dimmer Curve.
3. Select Linear (increase in light intensity is linear), Square (light intensity control is finer at low levels
and coarser at high levels), I Squa (light intensity control is coarser at low levels and finer at high
levels), or SCurve (light intensity is finer at low and high levels, and coarser at medium levels).
Dimmer Speed
To set the dimmer speed, do the following:
1. Go to the Setup main level.
2. Select Dimmer Speed.
3. Select Smooth or Fast.
34
COLORado PXL Curve 12 User Manual Rev. 4
Operation
Advertisement
Table of Contents
