Table of Contents
Advertisement
Setup
USB Software Update
The COLORado PXL Curve 12 allows for software update through USB using the built-in USB port. To
enable or disable this function, follow the instructions below:
1. Go to the Setup main level.
2. Select USB Update.
3. Select NO (disables updating by USB) or YES (enables updating by USB).
To update the software using USB flash drive, do the following:
1. Power on the product, and plug the flash drive into the USB port.
2. Once the flash drive has been detected, the message "USB UPDATE" will be displayed. Select YES.
3. The next screen will show the software versions available for this fixture on the USB drive. For
multiple versions of the software for the same fixture, use <UP> or <DOWN> to select the desired
version. Press <ENTER>.
4. The "USB UPDATE" screen will re-appear. Select YES.
It is possible to update multiple units with the USB if they are daisy chained via DMX.
5. The upgrade will start. DO NOT turn off the power or disconnect the USB while the USB LED is
still blinking during the process. The screen display will read: "USB Update Wait". The update can
take several minutes to complete.
•
When the USB firmware is done uploading, in some fixtures, the display will change to:
"DO NOT UNPLUG, UPDATING".
6. When the update is completed, the fixture will automatically reboot.
7. Go to Fixture Information on the product's menu map and confirm the firmware revision.
•
When the boot-up process is finished, restart the product.
• Place the .chl file in the root directory of the USB drive.
• The product's USB port supports up to 32GB capacity and only works with FAT32 file format.
Turning off the power or removing the USB while the USB LED is still blinking during the
update will cause partial or total firmware failure in the targeted fixture(s). If this occurs, the
user will need the UPLOAD 08 device to fix this. Please contact Chauvet regarding this device.
COLORado PXL Curve 12 User Manual
9
Advertisement
Table of Contents
