Table of Contents
Advertisement
Mounting
Before mounting the product, read and follow the safety recommendations indicated in the
For the Chauvet Professional line of mounting clamps, go to: http://trusst.com/products/.
Orientation
Always mount this product in a safe position, ensuring that there is adequate room for ventilation,
configuration, and maintenance.
Rigging
Chauvet recommends using the following general guidelines when mounting this product:
•
Before deciding on a location for the product, always make sure there is easy access to the product
for maintenance and programming.
•
Make sure that the structure onto which the product is being mounted can support the product's
weight (see the
Technical Specifications
•
When mounting the product overhead, always use a safety cable. Mount the product securely to a
rigging point, whether an elevated platform or a truss.
•
When rigging the product onto a truss, use a mounting clamp of appropriate weight capacity.
•
When power linking multiple products, mount the products close enough for power-linking cables to reach.
•
The bracket adjustment knobs allow for directional adjustment when aiming the product to the desired
angle. Only loosen or tighten the bracket knobs manually. Using tools could damage the knobs.
Procedure
The Ovation Rêve E-3 IP comes with a double-bracketed yoke that can be used as a floor stand or to which
mounting clamps can be attached for hanging. Mounting clamps must be purchased separately. Ensure that the
clamps can support the weight of this product. Use at least one mounting point per product where necessary.
Mounting Diagram
Mounting clamp
Mounting bracket
Secure the safety cable using
the passageway on the top of
the product
10
for weight information).
Overhead Mounting
Ovation Rêve E-3 IP User Manual Rev. 5
Setup
Safety
Notes.
Safety cable
* Lens tubes sold separately
Advertisement
Table of Contents
