Outgoing Call - Avaya 375 Series Using Manual

Procedure
To end a call, press the On-hook and On/Off (
The handset displays the duration of the call.

Outgoing call

Dialing a number (Pre-Dial)
Enter the number and press
If needed, press "Clear" to erase the number. By using the navigation key it is possible to step and
add or delete a digit in a number.
The tone sender in a pre-dialed number can be turned on by long pressing
An international number can be dialed from the handset by entering a + character followed by the
country code and local number. To enter the + character, long press the 0 key until the character is
shown in the display.
Note:
The + character cannot be entered and international numbers cannot be dialled in the
following circumstances:
• If the 0 key has been configured as a hot key.
• If the handset has been set up to perform advanced functions normally used by a system
administrator.
Dialing a number with the headset button
Procedure
If a headset is used, use the headset button to obtain a dial tone and dial the last number.
Ensure that the headset is configured using WinPDM or Device Manager.
Dial using a pre-programmed number
You can configure the Navigation key, Hot key, Soft key, or Multifunction button with a handset
number. You can even configure a headset button with a handset number as long as it has been
configured by the administrator via the WinPDM/Device Manager.
To dial a pre-programmed number, press the pre-Programmed key or button. The call gets
connected automatically.
Dialing a number from the call list
Procedure
1. In the ideal mode press the Down navigation key or navigate to Menu > Calls > Call list.
2. Select a number.
August 2023
) key.
to get the line. The number is shown on the display while dialing.
Using Avaya Wireless Handset 375x
Comments on this document?
Calls
.
59