Troubleshooting From Symptoms
No Power From the Output Terminals
Check:
Mains connected to the input
Mains Disconnect Switch
Outputs Enable Switch
Emergency Shutdown (EMO) switch
Circuit breakers
Voltage Selector Switch (S1)
Main/Branch Switch (S2) or connections
No Power From the Outlets
Check:
Mains connected to the input
Mains Disconnect Switch
10 AF 250 V fuses (2110-0051) on the input terminal block (see "Fuses" below) *
See "No Power From the Output Terminals **
*
If the outlets are wired for un-switched operation
** If the outlets are wired for switched operation
Branch Control Does Not Work
Check:
Main/Branch switch (S2) set incorrectly (page 19).
Branch In/Out terminals not wired with the correct polarity (page 19).
SERVICE INFORMATION
HP E1135C POWER DISTRIBUTION UNIT Rev. C
35