100/200-120/240 V Single Phase With Center-Tap Neutral - HP E1135C Operating And Service Manual

100/200–120/240 V Single Phase with Center-Tap Neutral
Figure 18. Wiring the Mains: 100/200
Tools for connecting the mains, loads and jumper:


1/4-inch flat blade screwdriver for the Mains Disconnect Switch


1/8-inch flat blade screwdriver for the Output Terminal Block


wire jumper between T2 and T3 (page 24)
Set the Voltage Selector Switch (S1) on the Control Board to 230V (page 9).
Wiring Loads: Wire line-to-line or line-to-neutral.
WIRING THE AC MAINS AND LOADS TO THE PDU
L1 L2 L3 N
1
0
G
T1 T2 T3 N
L1 L2 N
G

120/240 V Single Phase with Center-Tap Neutral
HP E1135C POWER DISTRIBUTION UNIT Rev. C
10A 10A
29