Removing The System Memory (Ram) - Clevo W340EU Service Manual

Disassembly

Removing the System Memory (RAM)

Figure 12
RAM Module
The computer has two memory sockets for 204 pin Small Outline Dual In-line Memory Modules (SO-DIMM) supporting
Removal
DDRIII (DDR3) Up to 1066/1333 MHz. The main memory can be expanded up to 8GB. The SO-DIMM modules sup-
ported are 1024MB and 2048MB DDRIII Modules. The total memory size is automatically detected by the POST rou-
a. Locate the memory
tine once you turn on your computer.
module(s) on the
mainboard.
Memory Upgrade Process
b. Pull the release lat-
ches.
1. Turn off the computer, remove the battery
c. Remove the module.
2. The RAM modules will be visible at point
3. Gently pull the two release latches (
arrows
4. The RAM module
5. Pull the latches to release the second module if necessary.
6. Insert a new module holding it at about a 30° angle and fit the connectors firmly into the memory slot.

7. The module will only fit one way as defined by its pin alignment. Make sure the module is seated as far into the slot
as it will go. DO NOT FORCE IT; it should fit without much pressure.
Contact Warning
8. Press the module in and down towards the mainboard until the slot levers click into place to secure the module.
Be careful not to touch
9. Replace the component bay cover and screws accordingly.
the metal pins on the
10. Restart the computer to allow the BIOS to register the new memory configuration as it starts up.
module's connecting
edge. Even the cleanest
a.
hands have oils which
can attract particles, and
degrade the module's
performance.

4. RAM Module
2 - 16 Removing the System Memory (RAM)
&
2
(Figure 12b).
will pop-up ( Figure 12c
4
1
(page 2 - 5) and the component bay cover
on the mainboard (Figure 12a).
1
) on the sides of the memory socket in the direction indicated by the
3
) , and you can then remove it
b.
2
3
(page 2 - 6).
.
c.
4